Recent content by plstktnkr2

  1. plstktnkr2

    '00 3.8 to 4.3 Build

    This is the same basic build I am doing but I am using a "Super Coupe" engine as a starting point. My blog on my build is at: More than "just a six"
  2. plstktnkr2

    Questions about H/C/I swap and Rocker Arms/Pushrods

    Yes you will need girdles, yes you will need hardened pushrods. I have a set of standrd pushrods that are thin and bent to prove it,lol Rick
  3. plstktnkr2

    how much have you put into your car?

    $25,000 ground up resto-mod, minus audio and recovered seats
  4. plstktnkr2

    Crown Vic to be phased out by '11

    really? so how have you seen my fleet all the way from houston? an SR-71? and since your SOOO lierate how did you find them all since not all are in one spot?
  5. plstktnkr2

    Crown Vic to be phased out by '11

    really? you would know this how?
  6. plstktnkr2

    Crown Vic to be phased out by '11

    do some of you remember the tempo police cars with the dual exhausts? baltimore used them till they got all crown vics
  7. plstktnkr2

    Official What did YOU just buy?

    1986 GT vert and $1100.00 bucks of tranny work because a company didnt send me all the right parts been an expensive month
  8. plstktnkr2

    How to build a V6 cheap.

    96StAnG3.8, you are correct, I bought a 3.8 super plus 5 spd for 200 bucks and sold the trans for 250bucks and still have the whole engine and CPU :) get an AOD because Im told the T-5 doen't hold up well
  9. plstktnkr2

    Official What did YOU just buy?

    Just bought: 1990 thunderbird super coupe engine, tranny, intercooler, tubes, and ECU-$200.00
  10. plstktnkr2

    How to build a V6 cheap.

    your welcome ask me what you need I have my own 4.2 so ask away
  11. plstktnkr2

    How to build a V6 cheap.

    yes
  12. plstktnkr2

    How to build a V6 cheap.

    4k for forged bottom end- machine work is about half, 6 forged pistons= 400 bucks remachined offset ground crank-? forged rods at least 400-600 bucks rings ,bearings (both rod and mains) 200 bucks main stud girdle 75-100 bucks ARP studs 200 bucks now you can see why a morana or...
  13. plstktnkr2

    How to build a V6 cheap.

    what do you wanna do with the car? I would get a shortblock,forged 4.2 and have my heads ported here or let tom do them if you have the coin to do so
  14. plstktnkr2

    How to build a V6 cheap.

    yes! Tom is a fair guy and knowlegable too
  15. plstktnkr2

    How to build a V6 cheap.

    forged 4.2 pistons are 400 bucks a set, forged rods the same
Top