Search results

  1. 1

    split port swap running but not right

    Thanks i'll try to locate them and call them. I heard of someone tuning in sumter but i can't remember the name of the shop, thanks.
  2. 1

    split port swap running but not right

    I really, honestly think that my cps is still not right. The pic on rpm's site isn't really clear because of the angle the pic was taken. Any help? Also i am having no luck finding anyone that can tune my car. Does anyone know anybody that can tune my car near south carolina? I am willing to go...
  3. 1

    south carolina chip tuner

    Does anyone know anybody in sc that can do chip tunes? I need my sct chip tuned badly so any references are appreciated.
  4. 1

    split port swap running but not right

    Well i have a sct chip installed that was supposed to be burnt for the injectors, etc. I got it from rpm. My thinking is that the chip just needs adjustment. Does anybody know where i can get my car tuned near south carolina? Thanks alot guys. P.S. check my mods list, there is everything i have...
  5. 1

    split port swap running but not right

    I did swap injectors to 21's and i've went over the vacuum lines again and again and they seem to all be right. Also i put the tps off of my single port on the splitport intake and it didn't make any difference. Also the check engine light isn't on but can i still get codes? One other thing, i...
  6. 1

    split port swap running but not right

    Well, i reset the computer and it now idles better. It still takes about 4 or 5 times of cranking and shutting off before it will stay running. Also it stalls when i press on the gas still. One other thing, why would the air bag light flash constantly all of a sudden? Any suggestions would be...
  7. 1

    split port swap running but not right

    Ok so i finally have it running after setting the cps right. Now here's the problem. When i goto wot the car stalls. Also when i put it in gear, it will shut off if i don't give it gas. Just to be curious i unhooked the cps and the tps while it was running and it continued to run the same. Also...
  8. 1

    now whats the problem

    Goto rpm's website, he has photos and instructions on the cps.
  9. 1

    now whats the problem

    Someone had put the cps in the wrong place and the moon on the inside was totally out of place. Also i found out that my egr vaccum line wasn't hooked up! Hopefully it'll run right when i get the starter on! Wish me luck. BTW i put a new fuel pump on, changed the fuel filter, and drained all of...
  10. 1

    now whats the problem

    Ok guys, i took the photos from rpm's website of the camshaft position sensor, and my cps was totally off. The moon on the inside of the sensor was in the wrong place by half a turn, but i have it in the correct place now. The sensor itself had its plug pointing towards the water pump hoses! I'm...
  11. 1

    now whats the problem

    Does anyone have any explanations for this problem?? I've racked my brain and i can't figure it out. I need some help because there isn't any good mechanics around here that knows how to work on modern vehicles.
  12. 1

    now whats the problem

    Ok, i finally got my car running after 15 minutes of it stumbling then cutting off. Heres what it'll do once it cranks: it'll rev to 2,000 rpms and die down, well i will pat the gas and keep it cranked for a few seconds, then the air bag light and the o/d off light will flash. From there, it'll...
  13. 1

    back fire please help

    Well today i took the fuel line off and let it pump some gas in a bottle. The gas was very dark and had hardly no smell. So, therefore i'm guessing that the fuel is no good and plus its 87. I sprayed a little bit of gas in the intake and it crunk up. Then, after a couple times of doing this, it...
  14. 1

    back fire please help

    Ok, i finally, after 2 years, have my 3.8 running but here's the problem. I think that the gas in the tank is old plus its 87 and my chip is burnt for 93 octane. Well i have to squirt gas in the intake for some reason to get it cranked. Tonight when i squirted gas in the intake it spit fire back...
  15. 1

    split port swap now running but not right please help

    Ok, how do i tell when a piston is at top dead center? And does any pistons be at top dead center at the same time? If so, which ones. Also i didn't mark where the cps was when i pulled it out so could someone give me a photo so i can get an idea? I looked at the photo at rpm but i couldn't...
  16. 1

    split port swap now running but not right please help

    i don't need 19's i needed 21's which i already have ordered. i have heard of a tool to set the timming. everyone on here says to have the cps in the right place when the harmonica balancer is at 0* and the computer will set the timing. So i am going with the guys on here because stevec and...
  17. 1

    split port swap now running but not right please help

    One more probelm, whenever i pulled the cps out i didn't mark where it was, how can i determing where it needs to be.
  18. 1

    split port swap now running but not right please help

    Umm, whenever i put the new injs. in, the car should run right if i have the right mafs, right? Also, how long will it take for the computer to set the timming? Hopefully i have the right mafs and every thing will go good. One more question, i have the 1.8 roller rockers and i was wondering...
  19. 1

    split port swap now running but not right please help

    Ok guys i have found some 21 injs. made by accel that have the old syle plug(not the pencil style), that way i can just put them right on without having to change my harness. Has anyone ever used these or heard of them? I have been searching around and i didn't know that somebody makes 21's for...
  20. 1

    split port swap now running but not right please help

    Sorry its been so long since i replied but my chip was burnt for my stock maf, i think, but i know for a fact the chip was burnt for 21 injs. My question is where is the cheapest place to get the 21's and where can i find the plugs for them. Also, i was wondering, is there any 21's with the 14...
Top