Welcome To V6Mustang.com!

We are the oldest and largest V6 Mustang forum on the internet. If you have any questions about your V6 Mustang or just want to connect with other V6 Mustang owners around the world, you have found the best place on the internet to do that.

Registering is free and easy! Hope to see you on the forums soon!

hello from sarnia ontario canada

Discussion in 'Introductions' started by Gary fraser, Nov 27, 2016.

  1. Gary fraser

    Gary fraser New Member

    Joined:
    Nov 27, 2016
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    I have a 2008 4.0l pony package. vortech blown with 16psi, ported and polished heads with 1.86" intake and 1.60" exhaust valves. custom intake manifold and custom 2" stainless headers. custom ground camshafts from crane cams. custom built 5r55s trans with 4000 stall converter from level 10 in new jersey. 4.10 gears in a 8.8 rear with bmr upper and lower control arms. it has manley rods and forged manley pistons also. the car ran12.46 @ 110.66 mph before the cams were ordered .the cams are not installed yet.it has a cooling mist meth injection system with a custom built 4 gallon aluminum meth tank I built. it has an aluminum drive shaft from shaftmasters. it made 415.6rwhp and 388.9rwtq in 2011 before the motor was built and heads done etc just the stock motor and vortech blower. I would like to see 475rwhp with new cams and new tune. I am switching over to 60lb injectors also. I just got a new 400lph fuel pump for it so no problems with running out of fuel.
     
  2. Phil II

    Phil II Cone Destroyer Staff Member

    Joined:
    Sep 19, 2013
    Messages:
    1,442
    Likes Received:
    214
    Trophy Points:
    73
    Location:
    Columbia, South Carolina
    Sounds like fun!