Welcome To V6Mustang.com!

We are the oldest and largest V6 Mustang forum on the internet. If you have any questions about your V6 Mustang or just want to connect with other V6 Mustang owners around the world, you have found the best place on the internet to do that.

Registering is free and easy! Hope to see you on the forums soon!

mt82 trans issues

Discussion in '2011-2014 V6 Mustang Tech' started by Lemac, Feb 3, 2016.

  1. Lemac

    Lemac New Member

    Joined:
    Aug 27, 2015
    Messages:
    17
    Likes Received:
    8
    Trophy Points:
    3
    Location:
    Madera
    long story short trans was making sound like throw out bearing going out. so I ordered new excedy throw out/ slave cylinder and while I was doing this myself decided to replace flywheel with the spec aluminum flywheel and spec stage 1 clutch. pulled trans, swapped parts and test drive. car still makes noise (at idle sounds like loose bearing, push clutch pedal down goes away) I pull trans again replace pilot bearing palm to face should have done that first time around. Well all back together and problem still exist. I also get a small amount of knocking with a light load, low rpm like 2k and under. I've read somewhere that some of the v8 guys had the bearing fail on the input shaft going into the trans, has anyone experienced this. I'm afraid to take the car to the dealer with aftermarket parts that might cause them to not cover under warranty, and I really dont want to pull trans to put stock parts back it, but if I have to i will.
     
  2. Phil II

    Phil II Cone Destroyer Staff Member

    Joined:
    Sep 19, 2013
    Messages:
    1,421
    Likes Received:
    207
    Trophy Points:
    73
    Location:
    Columbia, South Carolina
    Are still otherwise covered on the drivetrain by a warranty? Rework on rework is super crappy.