Vortech windstar vac lines

02edge

Active Member
hopefully somebody can chime in I plumbed my windstar as follows: off the barb on the front drivers side teed to my blow off valve, vac gauge, and fpr the two barbs on the back drivers side one goes just to the brake booster and the other goes to the 1/4" line that t's and goes into the firewall for the heater and the barb ontop by where the factory iac was goes to the 3/8" line im guessing for the charcoal cannister.. Oh and do I plug both ports on the vortech intake tube since I'm not running a pcv
 

JeffSeb

Well-Known Member
Yeah you will need to plug the inlet pipe if you do not have your crank case vented to it.
 

02edge

Active Member
With this setup should I run the pcv the factory way,with just breather filters on both, one filter and the other side to the intake, or run a catch can setup
 

JeffSeb

Well-Known Member
Not sure the best route for PVC, I have it into the intake of the head unit.

Take a picture of what you don't know where it goes
 

02edge

Active Member
image (4).jpg
the one on the top
 
Top